The technology
A tested autothermal reformer, ready to be taken further.
A self-heating, single-module design, developed through six hardware iterations and run as a pre-commercial prototype (about TRL 4–5).
8–12 kg
Hydrogen per day, rated range (about 8 conservative; about 12 measured average)
33–36% H2
Cylinder samples of the product gas, analyzed by an independent US laboratory
Six iterations
100+ tests and 350+ hours of reforming
Up to 10.5 h
Longest continuous run
The HR-100 is fed with methanol, steam and air, and recirculates recovered water. It has been tested on methanol only. Other feedstocks have been evaluated at laboratory scale only.
Figures are internal development data from a pre-commercial prototype and are subject to independent verification. Detailed data is available under NDA.
Feedstock
Fuel supply: methanol and ethanol at global scale
Methanol is already a bulk industrial chemical, produced and shipped worldwide through an existing network of plants, ocean tankers and storage terminals. The Methanol Institute reported global methanol supply of 94 million metric tons in 2024, from plants in many regions, including China, the Middle East, the Americas and Southeast Asia. Installed capacity is larger than current output.
Most methanol today comes from conventional fossil feedstocks. Renewable methanol — bio-methanol from biomass or waste, and e-methanol made with renewable hydrogen — is still a small share of supply: 0.4–0.5 million tons sold in 2024, and about 0.9 million tonnes of annual production as of 2026, according to the Methanol Institute. A large project pipeline has been announced, though only a portion is expected to be built by 2030. Methanol bunkering is expanding: Clarksons, cited by the Institute in 2025, counted 15 ports with active service and about 20 more developing it.
Ethanol is also produced at large scale, mainly as bioethanol for fuel. Global fuel ethanol output was about 31.4 billion gallons (about 119 billion litres) in 2024 and about 32.0 billion gallons in 2025, with the United States and Brazil together supplying roughly four-fifths. These ethanol figures are market context only. The HR-100 has been tested on methanol only. Using ethanol as a reformer feedstock would require further development.
Key figures
| Figure | Value | Data year | Source |
|---|---|---|---|
| Global methanol supply | 94 million metric tons | 2024 | Methanol Institute, 2025 Milestones |
| Renewable methanol sold | 0.4–0.5 million tons | 2024 | Methanol Institute, 2025 Milestones |
| Renewable methanol production | about 0.9 million tonnes a year | 2026, as stated by the Institute | Methanol Institute website and 1 September 2026 release |
| Announced renewable and low-carbon methanol pipeline | 45.8 million metric tons of potential capacity by 2030; 7–14 million tons more likely | Snapshot as of February 2025 | Methanol Institute / GENA Solutions, in 2025 Milestones |
| Global fuel ethanol production | 31.36 billion gallons (about 119 billion litres) in 2024; 32.0 billion gallons in 2025 | 2024 and 2025 | Renewable Fuels Association |
| U.S. and Brazil share of fuel ethanol | United States about 52% and Brazil about 29% in 2024 (together about 80%); about 52% and 27% in 2025 | 2024 and 2025 | Renewable Fuels Association; 2024 combined share also in the World Bioenergy Association 2025 summary |
| Ports with methanol bunkering | 15 ports with active bunkering; about 20 more developing capability | Cited by the Methanol Institute in 2025, attributing the count to Clarksons | Methanol Institute, 2025 Milestones |
Process
How it works
01
Methanol, steam and air
Three feeds
02
Autothermal reformer
Water recirculated
03
Hydrogen-rich reformate
About 33–36% H2 in cylinder samples
04
Clean-up as needed
CO cleanup, PSA or membrane
05
End use
Fuel cells, on-site hydrogen, backup and off-grid power
Autothermal
Air supplies the heat of reforming inside the reactor. No external burner.
Water recirculation
Water is recovered from the product gas and returned to the process.
Modular
A single compact module. Identical units can, in principle, run side by side to scale output.
Looking ahead
A scale-up concept
A larger multi-module design has been explored for bigger sites. It is a design idea only and has not been built or tested. The opening image is a rendering of that idea, not a photograph of existing hardware. An acquirer or licensee would start from the tested methanol prototype and know-how.
Evidence
The working prototype, and a methanol demonstration.
The HR-100 hardware is available for inspection. The photographs below are real, not renderings. They show the enclosed working prototype, the open-frame development unit, and a methanol demonstration.
Use
Applications
Potential uses for an acquirer or licensee to develop. The HR-100 has not been deployed commercially.
Fuel cells
On-site hydrogen for fuel cells
Methanol is reformed on site to a hydrogen-rich gas that can feed high-temperature PEM or solid-oxide fuel cells, with clean-up matched to the stack.
Power
Off-grid and backup power
Liquid methanol can be stored and delivered where hydrogen deliveries are costly or unreliable, including remote, backup and prime-power use.
Carrier
E-methanol as a hydrogen carrier
E-methanol and bio-methanol carry hydrogen in liquid form. On-site reforming can release that hydrogen where it is used, including industrial sites and ports.
These are potential applications, not existing deployments or customers.
The offer
What's available
The HR-100 technology is offered for acquisition, licensing or transfer.
Proprietary reformer design and catalyst know-how. Technical details available under NDA.
Know-how
Intellectual property and know-how
The system design, operating know-how, and proprietary reforming catalyst know-how, including a catalyst for CO cleanup.
Hardware
Prototype hardware
The working HR-100 prototype, available for inspection.
Data
Data room under NDA
Test records, run logs and independent laboratory gas analyses, shared under a mutual NDA.
People
Inventor and founder consulting
Dr. Bojidara Grigorova, principal inventor, and Dr. Steven Kadiev, founder, are available to consult with an acquirer or licensee on the earlier work.
Acquisition
Purchase of the technology, know-how and related materials.
Licensing
Exclusive or non-exclusive licenses, by field of use or region.
Technology transfer
Transfer of the prototype, data and know-how to a party that will develop it further.
Further development
Joint development and grant funding
The technology may suit joint development by an acquirer or licensee, including further work supported by non-dilutive grant funding. Public programs for hydrogen, fuel cells and small-business innovation are one possible path, subject to each program's rules and the applicant's eligibility.
Dr. Steven Kadiev, who led prior development, is available as a consultant to an acquirer or licensee on the earlier work. Detailed technical data is shared under NDA.
People
Team
Dr. Bojidara Grigorova
Principal inventor
Dr. Grigorova invented and developed the catalyst at the heart of the HR-100. Earlier in her career she was a research scientist and Manager Research at Anglo American Research Laboratories.
Dr. Steven Kadiev
Founder & CEO, Neo-H2
Steven leads Neo-H2 and handles all enquiries about acquisition, licensing or transfer of the HR-100 technology.
Contact
Enquire about the technology
For acquisition, licensing or evaluation, contact Dr. Steven Kadiev. Please send non-confidential information only in a first message.
Dr. Steven Kadiev, Founder & CEO
Neo-H2, LLC · Charlotte, North Carolina, USA
Also on LinkedIn
How an enquiry proceeds
- 01Initial enquiry
- 02Mutual NDA
- 03Data package review
- 04Inspection or evaluation
- 05Terms
A non-confidential technology summary is available on request. Detailed test data, test conditions and catalyst information are shared only under a mutual NDA.